# The minimum absolute value of the SDL analog joystick axis to move the N64 controller axis value from 0. # If True, then mouse buttons may be used with this controller # Specifies which type of expansion pak is in the controller: 1=None, 2=Mem pak, 5=Rumble pak

# Specifies whether this controller is 'plugged in' to the simulated N64 # Specifies which joystick is bound to this controller: -1=No joystick, 0 or more= SDL Joystick number # Controller configuration mode: 0=Fully Manual, 1=Auto with named SDL Device, 2=Fully automatic # Mupen64Plus SDL Input Plugin config parameter version number. For each axis, this must be greater than the corresponding AnalogDeadzone value # Underrun Mode, 0 = Ignore, 1 = Report, 2 = repeat audio when latency = AnalogPeak will saturate the N64 controller axis value (at 80). # Audio Output Frequncy mode (when NATIVE_MODE=false): 0 = Rom Frequency,$ # Number of output samples per Audio callback. # Point OMX to the raw N64 audio data region instead of copying audio int$ # Audio output to go to (0) Analogue jack, (1) HDMI # Frequency which is used if rom doesn't want to change it # Mupen64Plus OMX Audio Plugin config parameter version number # Filename of the disk to load into Disk Drive # This file is automatically read and written by the Mupen64Plus Core library My file looks like this # Mupen64Plus Configuration File You have to edit the /recalbox/share/system/configs/mupen64/ mupen64plus.cfg file, and add in this file your controller config.ДЄfter you have done this, your Controller should work fine. With the n64.configfile=dummy method i can't use the libretro core's only the standanlone Mupen64plus.

I can't simply make the file immutable since it's a fuse filesystem.ДЇeeling rather stuck here. Then I added n64.configfile=dummy to the /recalbox/share/system/nf but that resulted in the controller not being seen at all. This of course resulted in the file being overwritten when the emulator was launched and the buttons were incorrect. I first added the config to the /recalbox/share/system/config/mupen64/InputAutoCfg.ini. I have been searching for the answer to this but I just can't seem to get my N64-style generic controllers.

Callibrate retrolink n64 controller